The Web User
Interface (WUI) allows you to set up, modify, and view
router
configuration variables and operational data.
1. If the ADSL router is not on, turn on the
power. Wait about one minute.
2. In a Web browser on the PC, connect to
http://192.168.1.1/ to enter the router's
configuration program. The browser should
connect and you should see the Enter
Network Password screen shown below.
Type admin in the User
Name and Password fields, and click OK. These values
can
be changed later in the Web User Interface
(WUI).
After login, the Device Info screen appears:
>BNOTE :< font> If this screen does not
have values yet, this means you need to setup your
router by going to Begin Quick Setup.
1. Click Begin Quick Setup to start the setup process.
2. Enter the appropriate VPI :0 and VCI:35
and click next.
The Connection Type screen allows you to select the
type of network protocol over the ATM
PVC supported by the Internet Service Provider.
Refer to the beginning of this section for a
bridge description of these protocols.
Chose PPPoE and
click Next.
After Selected the appropriate Encapsulation Mode
Enter User name & password
Example: User@64.stars.net.sa
And click next.
- After entering your settings, click Next. The following screen appears:
This page allows the user to configure the LAN
interface IP address, subnetmask and
DHCP server, if the user would like this ADSL
router to assign dynamic IP addresses,
DNS server and default gateways to other LAN
devices. Select the button Enable DHCP
server on the LAN to enter the starting IP address and end IP address
and DHCP lease
time. Click Next after
completion. The following screen appears:
The Network Setup - Summary Screen presents the
entire configuration summary. Click
Finish if the settings are correct.
After clicking Finish, the router will save the configuration to delete
memory and reboot.
Now it is connected.
Created By Nouman Bashir
Dreamnet